Dimensioning to edges of a slot in techdraw

Dimensioning to edges of a slot in techdraw dimension a slot Pre-selecting sketch curves and then applying slot creates slots of equal size across all curves, lines, or arcs, linked together with one single dimension You dimensioning a slot Apart from creating vertical or horizontal slots, one can create an angled slot by using angle dimension Also there can be different ways to

dimensioning a slot exact rotor geometry information was not published, it was reconstructed based on a photograph from the same report Slot geometry is shown in Figure 2 The

dimension slot The tight key is a connection component fitting into the slot of the shaft and in the hub with torque being transmitted only by the sides of keys The key slots Casino slot machines are gambling machines where a game of slots is played by inserting coins and pulling a handle to randomize an alignment of symbols